Home | Available Used Machinery | New Machinery | Tell Us About Your Surplus Machinery | Appraisal | Email Us to Request a Quote.

 

Tsudakoma THNC-251 10" NC Tilting Rotary Table, New 1998.

 

 Tsudakoma THNC-251 10" NC Tilting Rotary Table

Specifications:

Tilt range...................................................................................... 0 - +93.

Table diameter.................................................................. 250mm (9.84").

Table height at 0 position................................................ 230mm (9.06").

Center height at 90 position............................................ 210mm (8.27").

Center bore nose diameter............................................................. 40H7.

Center bore through-bore................................................................... 32.

Table T-slot width............................................................................ 12H7.

Guide block width............................................................................. 18h7.

Rotary servo motor (Fanuc).............................................................. aiF4.

Speed reduction ratio....................................................................... 1/180.

Table max. rpm (with 2,000 rpm motor)........................................... 11.1.

Clamping torque......................................................................... 490 N-m.

Indexing accuracy (the sum).......................................................... 15 sec.

Repeatability.............................................................................. 4 arc sec.

Allowable work weight (horiz.-0)................................... 80 kg (176 lb.).

Allowable work weight (tilting -0-90)............................. 40 kg (88 lb.).

Dimensions......................................... 28"L x 16"D x 9"H (25.5" @ 90).

Weight (approx.)............................................................................ 275 lb.

 

Equipped with: 

NC controlled rotation.

Manual tilt.

Tilt crank handle.

Used with a Fanuc 18M control.

***USED LESS THAN 50 HOURS***.

 

SPECIFICATIONS ARE CORRECT TO THE BEST KNOWLEDGE OF THE SELLER BUT ARE NOT GUARANTEED.
BUYERS ARE ENCOURAGED TO CHECK IMPORTANT CHARACTERISTICS.

 

 

Please email us for a complete quotation. Include in the message your name, company name, location, phone number, and fax number.
We do not send quotations without this information.

Email Us to Request a Quote.


Home | Available Used Machinery | New Machinery | Tell Us About Your Surplus Machinery | Appraisal

 

Link to Direct Capital

- FINANCING BY DIRECT CAPITAL -.

 

This page created and maintained by
A. Green Co., P.O. Box 20118, Worcester, MA, USA, PH: 508-791-6800